Fuji Xerox DocuCentre-IV C3373 Administration Guide

15 Problem Solving
570
Problem Solving
15
149-210
149-211
149-212
149-213
149-214
149-215
149-216
149-217
149-218
149-219
149-220
149-221
149-224
149-225
149-228
149-229
149-232
149-233
149-234
149-235
149-236
149-237
149-238
149-239
149-240
149-241
149-242
149-243
149-248
149-251
149-252
149-253
149-280
149-281
149-282
149-283
149-284
149-285
149-286
149-287
149-288
[Cause] A hardware malfunction occurred in the High Capacity Stacker.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
149-310
[Cause] The machine was turned off during the downloading.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
149-700
[Cause] The output destination was changed to the Finisher Output Tray although you selected
the High Capacity Stacker.
[Remedy] Check whether the specified paper is supported by the machine.
Error Code Cause and Remedy

Fuji Xerox DocuCentre-IV C3373 Specifications

General

Brand	Fuji Xerox
Model	DocuCentre-IV C3373
Category	All in One Printer
Language	English