HP-GL/2 Emulation
701
Appendix
16
Extended Settings
Paper tray 103 Sets the paper tray to be used for printing.
[0] (Default) : Auto
[1] : Tray 1
[2] : Tray 2
[3] : Tray 3
[4] : Tray 4
[5] : Tray 5
[6] : Tray 6 (HCF B1)
Important • When Trays 1 to 4, Tray 6 is selected, the paper size is determined by the
size of paper loaded in the tray, and thus [Paper size] cannot be set.
Note • When [Auto] is selected and paper of the same size in the same orientation
in multiple trays is loaded, paper will be fed in the order of Tray 1 Tray 2
Tray 3 Tray 4 Tray 6. If paper of the same size is loaded in multiple
trays but in different orientations, feeding of the paper loaded in the
landscape orientation is prioritized.
Coordinate
rotation
104 Sets the paper orientation for printing.
[0] (Default) : 0 degree
[1] : 90 degree
Color mode 105 Sets the color mode.
[0] : Color
[1] (Default) : Grayscale
[2] : Black pen
Parameter Item No. Value
Parameter Item No. Value
Auto layout 106 Selects whether to perform auto layout of the document or not.
[0] (Default) : ON
[1] : OFF
Active palette 107 Selects whether to use a pen specified by command or set on the panel.
[0] (Default) : Command
[1] : Panel
No. of prints 108 Sets the number of copy to be printed.
[1] - [250] (Default: 1) : 1 - 250
Output
destination
109 Sets the output tray for the printouts.
[0] (Default) : Center Tray - Lower
[1] : Side Tray (optional)
[2] : Center Tray - Upper (optional)
[80] : Right Middle Tray (optional)
[81] : Right Top Tray (optional)
2 sided printing 110 Sets 2 sided printing.
[0] (Default) : None
[1] : Head to head
[2] : Head to toe
Alphanumeric
fonts
112 Sets the font for single-byte characters.
For more information on fonts, refer to "Internal Fonts" (P.654).
[0] (Default) : Stroke
[1] : Roman
[2] : Sans serif
To Next Page
Loading...
Need help?
General
