128 Troubleshooting
Color Registration Is Out of Alignment
NOTE:
• If the problem continues even though you have taken suggested actions described above, contact the Fuji Xerox local
representative office or an authorized dealer.
Problem Action
Color registration is out of alignment. Execute an auto color registration adjustment.
1 Launch the Printer Setting Utility, and click Registration Adjustment on the
Printer Maintenance tab.
2 Deselect the check box next to On.
3 Click Start next to Auto Correct.
Clean the CTD sensor.
1 Clean the CTD sensor.
2 Launch the Printer Setting Utility, and click Registration Adjustment on the
Printer Maintenance tab.
3 Deselect the check box next to On.
4 Click Start next to Auto Correct.
See also:
• "Cleaning the Color Toner Density (CTD) Sensor" on page 144
Print the color registration chart and manually correct the color registration.
1 Launch the Printer Setting Utility, and click Registration Adjustment on the
Printer Maintenance tab.
2 Deselect the check box next to On.
3 Click Start next to Print Color Regi Chart.
The color registration chart is printed.
4 Check the values with the straight lines on the chart.
5 Select the value for each color on the Printer Setting Utility.
6 Click Apply New Settings.
7 Click Start next to Print Color Regi Chart to print the color registration chart
again.
8 Adjust until all straight lines are at the value of 0.
See also:
• "Adjusting Color Registration" on page 130
To Next Page
Loading...
Need help?
General
