To Next Page

To Previous Page

42 Printer Connection and Software Installation

Windows Server 2008 or Windows Server 2008 64-bit Edition

NOTE:

• You must log in as an administrator.

1 Click Start  Control Panel  Hardware and Sound  Printers.

2 Click Add a printer.

3 Click Add a local printer.

4 Select the port connected to your printer, and then click Next.

5 Click Have Disk to display the Install From Disk dialog box.

6 Click Browse, and then select the extracted setup information (.inf) file in "Getting the Driver File" on page 41.

7 Click Open.

8 Click OK.

9 Select your printer name, and then click Next.

10 To change the printer name, enter the printer name in the Printer name box.

To use this printer as the default printer, select the Set as the default printer check box.

11 Click Next.

Installation starts.

12 If you do not share your printer, select Do not share this printer.

If you share your printer, select Share this printer so that others on your network can find and use it.

13 Click Next.

14 Upon completion of the driver installation, click Print a test page to verify installation.

15 Click Finish.

Windows 7, Windows 7 64-bit Edition, or Windows Server 2008 R2

1 Click Start  Devices and Printers.

2 Click Add a printer.

If the User Account Control dialog box appears, click Yes.

NOTE:

• If you are an administrator on the computer, click Yes; otherwise, contact your administrator to continue the desired

action.