169 Using the Operator Panel Menus
NOTE:
• This item is displayed only when the printer is connected with a wireless network.
• Init Wireless (DocuPrint CP205 w Only)
Purpose:
To initialize wireless network settings. After executing this function and rebooting the printer, all
wireless network settings are reset to their factory default values.
NOTE:
• This item is displayed only when the printer is connected with a wireless network.
•TCP/IP
Purpose:
To configure TCP/IP settings. The change becomes effective after the printer is turned off and then on.
Values:
•Protocol
Purpose:
To enable or disable each protocol. The change becomes effective after the printer is turned off and
then on.
Values:
WPS Push Btn. Ctrl Configures the wireless setting with the security method of WPS-
PBC.
PIN Code Start Config. Configures the wireless setting using the PIN code
assigned automatically by the printer.
Print PIN Code Prints the PIN code. Confirm it when you enter the
PIN code to your computer.
IP Mode Dual Stack* Uses both IPv4 and IPv6 to set the IP address.
IPv4 Mode Uses IPv4 to set the IP address.
IPv6 Mode Uses IPv6 to set the IP address.
IPv4 Get IP
Address
DHCP/AutoIP* Automatically sets the IP address.
BOOTP Uses BOOTP to set the IP address.
RARP Uses RARP to set the IP address.
DHCP Uses DHCP to set the IP address.
Panel Enables the IP address entered on the operator
panel.
IP Address Manually sets the IP address allocated to the
printer.
Network Mask Manually sets the subnet mask.
Gateway Address Manually sets the gateway address.
LPR Disable Disables the Line Printer Daemon (LPR) port.
Enable* Enables the LPR port.
To Next Page
Loading...
Need help?
General
