234
Home > Fax > Receive a Fax > Remote Fax Retrieval > Use Your Remote Access Code
Use Your Remote Access Code
1.
Dial your fax number from a telephone or another fax machine using touch tone.
2.
When your machine answers, immediately enter your Remote Access Code (three digits followed by *).
3.
The machine signals if it has received messages:
• One long beep -- Fax messages
• No beeps -- No messages
4.
When the machine gives two short beeps, enter a command.
• The machine will hang up if you wait longer than 30 seconds to enter a command.
• The machine will beep three times if you enter an invalid command.
5.
Press 9 0 to reset the machine when you are finished.
6.
Hang up.
• If your machine is set to Manual mode and you want to use the remote retrieval features, wait for about 100
seconds after it starts ringing, and then enter the remote access code within 30 seconds.
• This function may not be available in some countries or supported by your local telephone company.
• Remote Fax Retrieval
To Next Page
Loading...
Need help?
General
