318
Home > Network > Additional Methods of Configuring Your Fuji Xerox Machine for a Wireless Network >
Configure Your Machine for a Wireless Network in Ad-Hoc Mode (For IEEE 802.11b/g/n) > Configure Your
Machine for a Wireless Network in Ad-Hoc Mode Using an Existing SSID
Configure Your Machine for a Wireless Network in Ad-Hoc Mode Using
an Existing SSID
If you are trying to pair your Fuji Xerox machine to a computer that is already in Ad-Hoc mode and has a
configured SSID, use these instructions.
1.
Check and record the current wireless network settings of the computer to which you are connecting.
The wireless network settings of the computer you are connecting with must be set to Ad-Hoc mode with an
SSID already configured. For more information on how to configure your computer in Ad-Hoc mode, see the
instructions included with your computer or contact your network administrator.
For example:
Your Fuji Xerox machine supports the use of the first WEP key only.
2.
Press [] [Settings] > [All Settings] > [Network] > [WLAN] > [Setup Wizard].
3.
When [Enable WLAN?] appears, press [Yes].
This will start the wireless setup wizard. To cancel, press [No].
4.
The machine will search for your network and display a list of available SSIDs. If a list of SSIDs is displayed,
swipe up or down or press
▲
or
▼
to display the SSID to which you want to connect, and then press the SSID.
5.
Press [OK].
6.
Enter the WEP key, and then press [OK].
• Your Fuji Xerox machine supports the use of the first WEP key only.
7.
The machine attempts to connect to the wireless device you have selected.
Related Models: DocuPrint M385 z/DocuPrint M375 z
Before configuring your machine, we recommend writing down your wireless network settings. You will need
this information before you continue with the configuration.
Network Name (SSID)
Communication Mode Encryption Mode Network Key
Ad-Hoc NONE -
WEP
Network Name (SSID)
HELLO
Communication Mode Encryption Mode Network Key
Ad-Hoc WEP 12345
To Next Page
Loading...
Need help?
General
