166 Using the Operator Panel Menus
• WPS Setup (DocuPrint P255 dw only)
NOTE:
• This menu item appears only when the printer is connected to a wireless network.
• Reset Wi-Fi (DocuPrint P255 dw only)
Purpose:
To initialize wireless network settings. Enabling this feature and rebooting the printer will reset all the
wireless settings to their factory default settings.
Values:
NOTE:
• This menu item appears only when the printer is connected to a wireless network.
•TCP/IP
Purpose:
To configure TCP/IP settings. To make any changes effective, turn off the printer and then turn it back
on.
Values:
NOTE:
• To configure the IPv6 settings, use the CentreWare Internet Services.
Push
Button
Control
PBC Start Cancel* Disables the PBC method for the WPS encryption.
Start Enables the PBC method for the WPS encryption.
PIN Code Start
Configuration
Starts configuring wireless network settings using the PIN code
assigned automatically by the printer.
Print PIN Code Prints the PIN code to be entered on the computer for the WPS
encryption setup.
* Factory default menu setting
No* Does not reset the wireless setting.
Yes Resets the wireless setting.
* Factory default menu setting
IP Mode Dual Stack* Uses both IPv4 and IPv6 to set the IP address.
IPv4 Uses IPv4 to set the IP address.
IPv4 Get IP
Address
DHCP/AutoIP* Automatically sets the IP address.
BOOTP Uses BOOTP to set the IP address.
RARP Uses RARP to set the IP address.
DHCP Uses DHCP to set the IP address.
Panel Enter the IP address on the operator panel.
IP Address Enter the IP address allocated to the printer.
Subnet Mask Enter the subnet mask.
Gateway Address Enter the gateway address.
* Factory default menu setting
To Next Page
Loading...
Need help?
General
