Using the Operator Panel Menus 169
• Auto Reset
Purpose:
To specify a time period before the printer restores the default setting for the current menu item and
resumes the ready-to-print state when an attempt to change the setting is left unfinished.
Values:
• Fault Timeout
Purpose:
To specify a time period before the printer cancels a job that has halted abnormally. Any job will be
cancelled when it times out.
Values:
• Job Timeout
Purpose:
To specify a time period that the printer waits to receive data from a computer. Any print job will be
cancelled when it times out.
Values:
• mm / inch
Purpose:
To specify the measurement unit after the numeric value displayed on the operator panel.
Values:
45sec*
1min
2min
3min
4min
* Factory default menu setting
Off Disables the fault time-out feature.
On 60sec* By default, the printer cancels a job in 60 seconds after the job
halts abnormally. You can change the setting within a range
from 3 to 300 seconds.
3sec - 300sec
* Factory default menu setting
Off Disables the job time-out feature.
On 30sec* By default, the printer waits to receive data from a computer
for 30 seconds. You can change the setting within a range
from 5 to 300 seconds.
5sec - 300sec
* Factory default menu setting
Millimeters (mm)*
Inches (")
* Factory default menu setting
To Next Page
Loading...
Need help?
General
