-19-
Removing the Oven Door
For easier cleanups, the oven door can be removed.
1. Open the oven door fully as shown in the figure below.
2. Lift up and turn the small levers B located on the two hinges.
3. Grip the door on the two outer sides and close it approximately
half way.
4. Pull the door towards you lifting it out of the hinge slot.
To replace the door, ensure the seat D is hooked perfectly onto the
edge of the hinge slot, and then reverse the above mentioned
sequence.
Stainless Steel Front Panel
Use a soft, not abrasive cloth with warm soapy water to clean the control
panel and door panel of the oven. Dry the stainless steel surfaces with a
soft dry cloth.
Use non-scratch cleaning agents to clean the stainless steel surface and
always clean by following the grain direction.
WARNING! Do not use harsh chemicals, harsh cleaning agents or
any abrasive material on the control panel. Doing so may remove
the indicator markings which will not be covered by warranty.
WARNING! Do not use the steam cleaner, the warranty will not
cover the damage by the steam cleaner.
WARNING! Do not use the cleaning agents which contains soda,
acid, or chlorinum.
WARNING! Do not use cleaning sprayer, harsh abrasive cleaner or
sharp metal scrapers to clean the oven, the harsh cleaners may
scratch the surface.
To Next Page
Loading...
