PC Cards Preparation for use and operation
A26391-K96-Z100-2-7619 29
Inserting or removing a CD
The notebook must be switched on.
1
2
Ê Push the insert/eject button (1).
The CD tray will open.
Ê Pull the CD tray completely out.
Ê Place the CD in the CD tray with the labeled side facing upwards, and carefully push the CD
into the mount or remove an inserted CD.
Ê Push the CD tray in until you feel it locking into place (2).
Manual removal (emergency removal)
In the event of a power failure or damage to the drive it may be necessary to manually remove the
CD.
Ê Switch off the notebook.
Ê Push a piece of wire (such as a paper clip)
into the opening for manual ejection.
The CD tray is unlocked. You can now pull it out
of the drive.
PC Cards
A PC card slot (CardBus or PCMCIA) enables the notebook to operate one type II PC card or one
type III PC card.
!
The PC card must not consume more than 600mA (at +5V) or 60mA (at +12V).
Consult the documentation supplied by the PC card's manufacturer and follow the
instructions provided.
Never use force when inserting or removing a PC card.
Make sure that foreign objects do not fall into the PC card slot.
To Next Page
Loading...
Need help?
General
