To Next Page

To Previous Page

2.2 Loading Documents on ADF

This section explains how to check the document condition and load them on ADF. These opera-

tions are very important to avoid paper jam or scanning error.

2.2.1 Checking document condition

Check that the document meets the following condition.

■ Document Size

■ Document Type

The following paper types are recommended for ADF scanning:

• Woodfree paper

• Wood containing paper

When using documents other than above paper types, scan som test sheets of the same type

to see if the documents can be scanned or not, before attempting to scan the documents.

■ Document Thickness

Paper thickness is generally expressed by "paper weight". The following shows the paper

weights that can be used on this scanner:

• 52 g/m

to 127 g/m

(14lb to 34lb)

■ Precautions

The following documents may not be scanned successfully:

• Documents of non-uniform thickness (e.g. envelopes)

• Wrinkled or curled documents (Refer to HINTs on the next page)

• Folded or torn documents

• Tracing paper

• Coated paper

• Carbon paper

• Carbonless paper

• Photosensitive paper

• Perforated or punched documents

HINT

• If the documents do not meet the conditions, scan them on Flatbed

referring to "Loading Document on Flatbed" on page.16

• If you scan sheets of paper that is not recommended for feeding with

ADF, a paper jam may occur in the scanner or a wrinkle may occur on a

sheet. To prevent this from occurring, use Flatbed when scanning such

paper.

For ADF: Minimum 115 (Width) x 140 (Length) mm (4.53 x 5.51 in.)

Maximum 216 (Width) x 355 (Length) mm (8.5 x 14 in.)

Fujitsu 5015C - fi - Sheetfed Scanner User Manual

Other manuals for Fujitsu 5015C - fi - Sheetfed Scanner