Fujitsu AJ**A72LBTF - Rotary Switch Setting

En-26
4.11.3. ROTARY SWITCH SETTING
Rotary switch setting
The rotary switch is for setting the refrigerant circuit address.
Rotary switch (SW8) - - - Factory setting “0”
Rotary switch (SW9) - - - Factory setting “0”
In the case of multiple refrigerant circuits, set SW8 and SW9 as shown in the Table 4.11-15 for each refrigerant circuit.
Do not use a nonexistent switch setting combination. (Table 4.11-15)
Example: When SW8 is set to “4” and SW9 is set to “1”, the refrigerant circuit address will be “20”.
0 0020144028603C8050
1 0121154129613D8151
2 022216422A623E8252
3 032317432B633F 8353
4 042418442C6440 8454
5 052519452D6541 8555
6 06261A462E6642 8656
7 07271B472F6743 8757
8 08281C48306844 8858
9 09291D49316945 8959
10 0 A 30 1 E 50 3 2 70 4 6 90 5 A
11 0 B 31 1 F 51 3 3 71 4 7 91 5 B
12 0 C 32 2 0 52 3 4 72 4 8 92 5 C
13 0 D 33 2 1 53 3 5 73 4 9 93 5 D
14 0 E 34 2 2 54 3 6 74 4 A 94 5 E
15 0 F 35 2 3 55 3 7 75 4 B 95 5 F
16 1 0 36 2 4 56 3 8 76 4 C 96 6 0
17 1 1 37 2 5 57 3 9 77 4 D 97 6 1
18 1 2 38 2 6 58 3 A 78 4 E 98 6 2
19 1 3 39 2 7 59 3 B 79 4 F 99 6 3
Table 4.11-15
Refrigerant
circuit
address
Rotary
Switch Setting
OUTDOOR UNIT
SW9 SW8
Refrigerant
circuit
address
Rotary
Switch Setting
OUTDOOR UNIT
SW9 SW8
Refrigerant
circuit
address
Rotary
Switch Setting
OUTDOOR UNIT
SW9 SW8
Refrigerant
circuit
address
Rotary
Switch Setting
OUTDOOR UNIT
SW9 SW8
Refrigerant
circuit
address
Rotary
Switch Setting
OUTDOOR UNIT
SW9
SW8
9374241033_IM_en_p18-36.p65 26/8/2008, 18:2326