To Next Page

To Previous Page

9) Room temperature sensor switching (Aux.)

To use the temperature sensor on the wired remote controller only, change the setting to "Wired

remote controller" (01).

This function will only work if the function setting 42 is set at "Both" (01).

When the setting value is set to "Both" (00), more suitable control of the room temperature is pos-

sible by setting function setting 30 and 31 too.

Function number Setting value Setting description Factory setting

00 Both ♦

01 Wired remote controller

10) Indoor unit fan control for energy saving for cooling

Enables or disables the power-saving function by controlling the indoor unit fan rotation when the

outdoor unit is stopped during cooling operation.

Function number Setting value Setting description Factory setting

00 Disable

01 Enable ♦

00: When the outdoor unit is stopped, the indoor unit fan operates continuously following the set-

ting on the remote controller.

01: When the outdoor unit is stopped, the indoor unit fan operates intermittently at a very low

speed.

DESIGN & TECHNICAL MANUAL

- 30 -

DUCT TYPE

ARHG24LMLA

Fujitsu ARHG24LMLA User Manual

Questions and Answers: