08-01
8-1. FUNCTION SETTING
Follow the instructions in the Local Setup Procedure, which is supplied with the remote control,
in accordance with the installed condition.
After the power is turned on, perform the Function Setting on the remote control.
The settings may be selected between the following two: Function Number or Setting Value.
Settings will not be changed if invalid numbers or setting values are selected.
8-1-1 INDOOR UNIT
1-1. Setting the Cooler Room Temperature Correction
( Factory setting)
Setting Description
Function Number Setting Value
Standard
Lower control
30
00
01
Depending on the installed environment, the room temperature sensor may require a correction.
The settings may be selected as shown in the table below.
1-3. Setting Other Functions
( Factory setting)
Setting Description
Function Number Setting Value
Yes
No
40
00
01
The following settings are also possible, depending on the operating conditions.
Auto Restart
( Factory setting)
Setting Description
Function Number Setting Value
Standard
Lower control
Slightly warmer control
Warmer control
31
00
01
02
03
1-2. Setting the Heater Room Temperature Correction
Depending on the installed environment, the room temperature sensor may require a correction.
The settings may be changed as shown in the table below.
To Next Page
Loading...
Need help?
General
