To Next Page

To Previous Page

- 31 -

WALL MOUNTED

ASYG09-14LZCA

4) Auto restart

Enables or disables automatic restart after a power interruption.

NOTE: Auto restart is an emergency function such as for power outage etc. Do not attempt to use

this function in normal operation. Be sure to operate the unit by remote controller or external

device.

5) Room temperature sensor switching

(Only for wired remote controller)

When using the wired remote controller temperature sensor, change the setting to "Both" (01).

00: Sensor on the indoor unit is active.

01: Sensors on both indoor unit and wired remote controller are active.

NOTE: Remote controller sensor must be turned on by using the remote controller.

6) Remote controller custom code

(Only for wireless remote controller)

The indoor unit custom code can be changed. Select the appropriate custom code.

7) External input control

"Operation/Stop" mode or "Forced stop" mode can be selected.

8) Room temperature sensor switching (Aux.)

To use the temperature sensor on the wired remote controller only, change the setting to "Wired

remote controller" (01).

This function will only work if the function setting 42 is set at "Both" (01).

When the setting value is set to "Both" (00), more suitable control of the room temperature is pos-

sible by setting function setting 30 and 31 too.