Setup Guide
Setup Guide
FUJITSU Storage
ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems
P3AM-7852-06ENZ0
An installation space and network environment must be prepared in advance.
Prepare the following manuals:
●
Manuals for the ETERNUS DX100 S3/DX200 S3
●
Related manuals, such as manuals for the server or the networking equipment that is used
Installation Space
Site Planning Guide
Network Environment
•
Configuration Guide (Basic)
•
Configuration Guide (Web GUI)
Preparation
STEP
Installation space
Check that the installation area meets the space requirements of the rack in which the ETERNUS DX is to be
installed.
Environmental considerations for installation
Check if the installation area for the ETERNUS DX meets the environmental conditions and installation environment
conditions.
Power outlets
Check the type and the number of power outlets/sockets that are required to install the ETERNUS DX.
Completing and attaching the Network Settings label
Write down the IP address for the ETERNUS DX on the Network Settings label and attach it inside the rack.
Settings for the PC
●
Set up the network environment
- IP address : 192.168.1.2
- Subnet mask : 255.255.255.0
●
Set the Web browser
Refer to "Configuration Guide (Web GUI)" for details on the settings that are required.
To Next Page
Need help?
General
