Fujitsu ESPRIMO D53 Series - Connecting the Keyboard; Connecting a USB Keyboard; Connecting a PS;2 Keyboard; Connecting External Devices to the Serial Interface

Connecting external devices
Connecting the keyboard
You can connect a USB keyboard o r a PS/2 keyboard to your device.
Keyboard,Connecting,
Connecting a USB keyboard
Use the supplied keyboard cable only.
USBport,Connecting,
► Plug the flat rectan gular US B connector of the keyboard cable into a USB port of the device.
USBport
Connecting a PS/2 keyboard
Use the supplied keyboard cable only.
ConnectingaPS/2keyboardConnecting,
The PS/2 keyboard is only detected by the device if you connect the keyboard
when the device is switched off and then switch the device on again.
► Switch your device off.
► Plug the round plug o
f the keyboard cable into a keyboard port of the device.
Keyboard,
► Switch your device on again.
Connecting external devices to the serial interface
SerialinterfaceSerialinterface,Externaldevices,Devices,
For an exact desc
ription of how to connect external devices to the corresponding
port, please se
e the external device documentation.
External devices (e.g. a printer or scanner ) can be connected to the serial port.
► Connect the data cable to the external device.
► Connect the data cable to the corresponding serial interface.
Port settings
Serialinterface,
You can c ha
nge the settings of the port in the BIOS Setup.
Device d
rivers
Devicedrive rs,
The devices connected to the serial interface require drivers. Your operating system
already includes many drivers. If the required drive is missing, install it. The latest
drivers are usually available on the Internet or will be supplied on a data carrier.
Fujitsu 19