Fujitsu ESPRIMO Q5020 - Drives Disassembly and Assembly

Service Manual ESPRIMO Q5020 page 7 of 13
Title:
Service Manual ESPRIMO Q5020
Target Audience: FTS Support and Service Partner
Organizations
Published by:
Fujitsu
Service and Support Center
Product Service Management Business PC
Joerg Reichelt
Service Manual ESPRIMO Q5020 V1.0.doc
Version: Page/Pages: http://extranet.ts.fujitsu.com/service/  Fujitsu Technology Solutions GmbH 2008
1.0 7 of 13
.
• No thermal grease is used for
this heat sink.
• Lock screws in the sequence
marked in the picture.
• If tape was applied then use this
tape to close the middle holes.
•Place the fan cable between heat
sink and screw.
• Check that the cable is plugged
in (red circle).
4. Drives disassembly & assembly
• Unscrew the 4 screws
(red arrows).
• If an (optional) Bluetooth-module
is mounted then carefully remove
the cable out of the plastics clip.
• Lift the drive cage a little (1.) then
remove the drive cage in the
direction of the yellow arrow (2.).
• Carefully remove unplug the an-
tenna cable from the bluetooth
module.
1
2
3
4
5
6
1.
2.