Fujitsu ETERNUS AB Series - Page 23

|Controllers|
Install fans
You must install the fans into the replacement controller canister. Install the fans by sliding them into the
shelf.
Before you begin
• You have an ESD wristband, or you have taken other antistatic precautions.
Procedure
1. Slide the fan all the way into the replacement controller.
2. Repeat until all fans are installed.
What to do next
Go to Install new controller canister
Install new controller canister
After installing the battery, power supply, DIMMs, fans, and the host interface card (HIC), if one was initially
installed, you can install the new controller canister into the controller shelf. Install the new controller shelf by
closing the cover and using the handles to slide the controller into the controller shelf.
Procedure
1. Lower the cover on the controller canister and secure the thumbscrew.
2. While squeezing the controller handles, gently slide the controller canister all the way into the controller
shelf.
23