|Drives |
4. If volumes have already been created and assigned, use a permanent marker to note the exact location of
each drive. For example, using the following drawing as a reference, write the appropriate slot number on
the top of each drive.
Attention: Possible loss of data access – Make sure to record the exact location of each drive
before removing it.
5. Remove the drives from the drive drawer:
a) Gently pull back the orange release latch that is visible on the center front of each drive.
b) Raise the drive handle to vertical.
c) Use the handle to lift the drive from the drive drawer.
d) Place the drive on a flat, static-free surface and away from magnetic devices.
6. Remove the drive drawer:
a) Locate the plastic release lever on each side of the drive drawer.
58
To Next Page
Loading...
