|Drives |
Lock-out tumbler Drawer guide
2. Position the replacement drive drawer in front of the empty slot and slightly to the right of center.
Positioning the drawer slightly to the right of center helps to ensure that the lock-out tumbler and the
drawer guide are correctly engaged.
3. Slide the drive drawer into the slot, and ensure that the drawer guide slides under the lock-out tumbler.
Attention: Risk of equipment damage – Damage occurs if the drawer guide does not slide under
the lock-out tumbler.
4. Carefully push the drive drawer all the way in until the latch fully engages.
Experiencing a higher level of resistance is normal when pushing the drawer closed for the first time.
Attention: Risk of equipment damage — Stop pushing the drive drawer if you feel binding. Use
the release levers at the front of the drawer to slide the drawer back out. Then, reinsert the drawer
into the slot, ensure the tumbler is above the rail, and the rails are aligned correctly.
What to do next
Go to Attach cable chains.
Attach cable chains
You must attach the cable chains so you can safely re-install the drives in the drive drawer.
Before you begin
• You have installed the new drive drawer.
• You have two replacement cable chains, marked as LEFT and RIGHT (on the horizontal connector next to
the drive drawer).
About this task
When attaching a cable chain, reverse the order you used when disconnecting the cable chain. You must
insert the chain's horizontal connector into the horizontal guide rail in the enclosure before inserting the
chain's vertical connector into the vertical guide rail in the enclosure.
60
To Next Page
Loading...
