Fujitsu ETERNUS AF650 S2 - Page 67

5. Adding a Connecting Device
Connection Procedure When Adding an ETERNUS DX/AF
FUJITSU Storage ETERNUS AF, ETERNUS DX Configuration Guide (Power Synchronized Unit)
Copyright 2019 FUJITSU LIMITED P3AM-8012-14ENZ0
67
5 Connect the ETERNUS DX/AF storage systems to the power synchronized units.
An example of a connection between five or more ETERNUS DX/AF storage systems and power synchronized
units is shown below.
For details about how to connect an ETERNUS DX/AF to the power synchronized unit, refer to "
Connecting to
the ETERNUS DX/AF" (page 57).
End of procedure
Power synchronization starts when connection is complete. Check that power synchronization performs normally.
Power synchronized unit#1
Power synchronized unit#0
Added ETERNUS DX/AF storage systems
Server#0
UPS unit for
Server#0
Server#1
UPS unit for
Server#1
PWC#0 PWC#1 PWC#2 PWC#3
RS232C cables
(optional)
RS232C cables
(provided with a
power synchronized unit)
ETERNUS DX/AF #4
PWC
ETERNUS DX/AF #5
PWC
ETERNUS DX/AF #6
PWC
ETERNUS DX/AF #7
PWC
ETERNUS DX/AF #0
ETERNUS DX/AF #1
ETERNUS DX/AF #2
ETERNUS DX/AF #3