The READY LED ( ) on the controller enclosure is turned off.
• After power-off, wait for about one minute before turning power on again.
• If the Power switch is pressed again between the time of the READY LED ( ) turning off and the
POWER LED ( ) turning off, the ETERNUS DX power may turn on.
2 The ETERNUS DX power is turned off.
The POWER LED ( ) of the controller enclosure and the POWER LEDs ( ) of the drive enclosures are
turned off.
■
When a Power Synchronized Unit is Used
If the server is turned off, the ETERNUS DX is also turned off.
Chapter 8 System Status Check
8.6 Powering Off
133
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7732-05ENZ0
To Next Page
Loading...
