•
Server-side settings
Install ETERNUS vCenter Plug-in and then register the ETERNUS DX as a management target device.
•
Settings for the ETERNUS DX
Enable SSH connections in the firewall settings of the network settings in ETERNUS Web GUI.
For mode details on the settings for ETERNUS vCenter Plug-in, refer to "ETERNUS vCenter Plug-in User's
Guide".
VASA Provider
Install ETERNUS VASA Provider in the storage management server in which ETERNUS SF Storage Cruiser is op-
erating.
•
Settings for ETERNUS VASA Provider
Install ETERNUS VASA Provider in the storage management server.
Perform the settings that are related to ETERNUS VASA Provider in the vCenter Server after installation.
•
Settings for ETERNUS SF Storage Cruiser
Before starting the ETERNUS VASA Provider service, register ESXi Server and the ETERNUS DX that is to be
monitored in ETERNUS SF Storage Cruiser.
Update the configuration file and enable linkage with the device event information to apply the ETERNUS
VASA Provider settings.
For more details on the settings for ETERNUS VASA Provider, refer to "ETERNUS VASA Provider User's Guide".
For more details on the settings for ETERNUS SF Storage Cruiser, refer to "ETERNUS SF Web Console Manual"
and "ETERNUS SF Storage Cruiser Operation Guide".
Chapter 9
Solution Configuration
9.4 Virtualization Platform
146
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7732-05ENZ0
To Next Page
Loading...
