Chapter 7 System Environment Settings
7.1 Required Settings for the Key Management Function
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED P2X0-1250-06ENZ0
109
(7)Update SED authentication key
Obtain the key that is to be registered in the key group from the key server.
Refer to "Update SED Authentication Key" in "ETERNUS Web GUI User's Guide (Settings)".
7.1.1.2 Check Key Status
(1)Key group
Check the communication status between the ETERNUS DX S3 series and the key server. If the key status
and the key server status are "Normal", communication between the ETERNUS DX S3 series and the key
server has been successfully established.
Refer to "Key Group" in "ETERNUS Web GUI User's Guide (Operation)".
When the [Update SED Authentication Key] function is performed at the first time, the process ends with
an error. Use the [Update SED Authentication Key] function until the key is successfully obtained. When
the key is successfully obtained, the key server status becomes "Normal". Up to three key updating pro-
cesses may need to be performed. The [Update SED Authentication Key] ends with an error until the key
is obtained.
• When the key updating function is used for the first time, the ETERNUS DX S3 series sends the SSL cer-
tificate to the key server. The key server waits for the SSL certificate to be registered. Register the SSL
certificate in the key server.
• When the key updating function is used for the second time, the key server waits for the ETERNUS DX
S3 series to be accessed.
• When the key updating function is used for the third time, the ETERNUS DX S3 series can obtain the
key from the key server.
The key server status can be checked on the [Key Group] screen. Refer to "Key Group" in "ETERNUS Web
GUI User's Guide (Operation)" for details.
For details on how to register the SSL certificate and accept the ETERNUS DX S3 series, refer to the manu-
als of the key management software "ETERNUS SF KM".
To Next Page
Loading...
