FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED P2X0-1250-06ENZ0
67
Chapter 5
Host Interface Management
The following section describes the series of settings when configuring host connection settings.
Add LUN Group
Add a LUN group (a group of volumes that are recognized from the server, which is
conventionally referred to as an "affinity group").
Correspond the volume number to the Logical Unit Number (LUN) that can be recognized by the
host for each LUN group.
LUN groups are allowed recognition from the server after host affinity is set.
Refer to:
-
Add LUN Group
Set Port Parameters
Set the parameter for the ETERNUS DX side host interface port.
Refer to:
-
Modify Port Parameters
Create CA Port Group
Create a CA port group (a group of CA ports that are connected to the specified host group) that
is used for the server to access the ETERNUS DX.
Refer to:
-
Create CA Port Groups
To Next Page
Loading...
