Chapter 5 Host Interface Management
5.2 Modify Port Parameters
FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)
Copyright 2014 FUJITSU LIMITED P2X0-1250-06ENZ0
82
● Send ping (IP address)
• IP Address
• Send Number
• Result
3 Click the [Modify] button.
A confirmation screen appears.
4 Click the [OK] button.
Modification of the iSCSI port parameters starts.
5 Click the [Done] button to return to the [iSCSI Port] screen.
• When the [Discovery] button is clicked for "IPv6 Connect IP Address", the IPv6 connect IP address
can be created automatically from the prefix value that is obtained from the router that is
connected to the ETERNUS DX and the input IPv6 link local address.
• When the [Discovery] button is clicked for "IPv6 Gateway", the gateway information can be
obtained from the connected router.
• When the port mode is "CA" or "CA/RA" and Multiple VLAN is enabled, click the [Add] button to
register up to 15 IP address information for each port.
• To check whether the IP address is allocated correctly and the connection status for the remote
device, click the [Test Connection (ping)] button for "IP Address", "IPv6 Link Local Address", or "IPv6
Connect IP Address".
To Next Page
Loading...
