Fujitsu Eternus DX80 S2 - Chapter 2 Setting up the ETERNUS DX; Common Settings; Setting the To-Server Connection Type (Setting the FC Port Parameters); Table 2.1 FC Port Parameter Settings (FC-AL Connection)

To Next Page

To Previous Page

Chapter 2

Setting Up the ETERNUS DX

2.1 Common Settings

This section explains the settings required for all server OSs, regardless of the connection configuration.

See the "ETERNUS Web GUI User's Guide" for details of how to set up and operate ETERNUS Web GUI.

2.1.1 Setting the To-server Connection Type (Setting the FC Port Parameters)

For each connection configuration, set the indicated items only. Retain the default values for all of the pa-

rameters that are not described below.

•

Specify "Fabric connection" for connections to the Fibre Channel switches.

•

Specify "FC-AL connection" for direct connections to the Fibre Channel cards. Specify "Fabric connection" for

direct connections to 16Gbit/s Fibre Channel cards (maximum transfer rate) with a transfer rate of 16Gbit/s.

Table 2.1 FC port parameter settings (FC-AL connection)

Parameter

Solaris OS

HP-UX, AIX, Windows

, Linux, VMware

ESX, PAN Manager, Citrix XenServer,

Oracle Linux, Oracle VM Server for x86

Connection FC-AL

Set Loop ID Manual

Loop ID Values from 0x10 upwards

(Except 0x7D)

0x00

Transfer Rate See the table below (*1)

FC Frame Size 2048

Reset Scope I_T_L

Release Reservation if Chip is Reset Disable

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-

P3AM-5332-15ENZ0

Other manuals for Fujitsu Eternus DX80 S2