Fujitsu Eternus DX80 S2 - Table 2.2 Transfer Rate Setting Values (for FC-AL Connection); Table 2.3 FC Port Parameter Settings (Fabric Connection); Table 2.4 Transfer Rate Setting Values (for Fabric Connection)

*1: Set the appropriate value from the following table. Do not use [Auto-negotiation].
Table 2.2 Transfer Rate setting values (for FC-AL connection)
Fibre Channel card maxi-
mum speed
Transfer rate setting value
16Gbit/s CA 8Gbit/s CA 4Gbit/s CA
16Gbit/s — 8Gbit/s 4Gbit/s
8Gbit/s 8Gbit/s 8Gbit/s 4Gbit/s
4Gbit/s 4Gbit/s 4Gbit/s 4Gbit/s
2Gbit/s — 2Gbit/s 2Gbit/s
Table 2.3 FC port parameter settings (Fabric connection)
Parameter
Setting value
Connection Fabric
Transfer Rate See the table below (*1)
FC Frame Size 2048
Reset Scope I_T_L
Release Reservation if Chip is Reset Disable
*1: Set the appropriate value from the following table.
Table 2.4 Transfer Rate setting values (for Fabric connection)
Fibre Channel switch maxi-
mum speed
Transfer rate setting value
16Gbit/s CA 8Gbit/s CA 4Gbit/s CA
16Gbit/s 16Gbit/s (*1) 8Gbit/s 4Gbit/s
8Gbit/s 8Gbit/s 8Gbit/s 4Gbit/s
4Gbit/s 4Gbit/s 4Gbit/s 4Gbit/s
2Gbit/s — 2Gbit/s 2Gbit/s
*1: Specify "Auto Negotiation" for direct connections to 16Gbit/s Brocade Fibre Channel cards.
When using a Fabric connection, complete the preparatory work and set up the Fibre Channel switch be-
forehand. For setting details, refer to "FUJITSU Storage ETERNUS DX Configuration Guide -Server Connec-
tion- (Fibre Channel) Fibre Channel Switch Settings" or "Fabric OS Administrator's Guide".
Chapter 2
Setting Up the ETERNUS DX
2.1 Common Settings
9
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-
Copyright 2015 FUJITSU LIMITED
P3AM-5332-15ENZ0