Fujitsu Eternus DX80 S2 - Page 17

Power On Procedure (2)
 Controller Enclosure LEDs
Copyright Fujitsu Technology Solutions, Release August 2011
Hardware Installation ETERNUS DX80 S2 and DX90 S2
POWER LED
 Constant green when the power is turned on
READY LED
 Constant green when device is available
for use
FAULT LED
 Constant amber when a failure is detected
in the ETERNUS DX system
 Blinks in amber when a component which
requires preventive maintenance is detected
MAINT/ID LED
 Constant green when the system has its
status set to Maintenance
 Blinks green
 Status of all components needs to be
verified with the GUI or CLI
 Locate functionality enabled by the GUI
or CLI
CACHE LED
 Constant green when data exists in cache memory
 Blinks in green when cached data is saved to the flash memory
16