Fujitsu Eternus DX80 S2 - Understanding CLI Command Syntax

Power Off Procedure
 Verify with the customer that all server I/O is stopped
 Also confirm that the "CACHE" LED in the Operator Panel is off
 Hold down the "Power Switch" of the Controller Enclosure for
approximately 5 seconds
 The ETERNUS DX system will shutdown all Enclosures gracefully
 In case of moving ETERNUS to a new location, you naturally
have to also disconnect the AC power cords
from the PDUs after the system is
powered off
Copyright Fujitsu Technology Solutions, Release August 2011
Hardware Installation ETERNUS DX80 S2 and DX90 S2
Make sure the CACHE LED
of the Controller Enclosure
is off
18