Fujitsu ETERNUS LT20 S2 - Setting Topology (FC Switches); Setting Host (FC HBAs); Setting the Mailslot

Chapter 2 Setting the LT20 S2/LT40 S2/LT60 S2
2.3 Setting the Mailslot
FUJITSU Storage ETERNUS LT20 S2/LT40 S2/LT60 S2 Tape Library User’s Guide -Server Connection-
Copyright 2021 FUJITSU LIMITED P3AM-5322-12ENZ0
33
2.2.3 Setting the Topology (for Connections via FC Switches)
The following settings are required for connections via FC switches.
Though "Automatic" can be selected for Topology, set the fixed value shown above.
For more details about the settings, refer to "FUJITSU Storage ETERNUS LT20 S2 LTO Library Installing, Starting
Up and Maintaining" or "FUJITSU Storage ETERNUS LT40 S2/LT60 S2 LTO Library Installing, Starting Up and
Maintaining".
2.2.4 Setting the Host (When Using FC Host Bus Adapters)
To connect the LT20 S2/LT40 S2/LT60 S2 to an FC host bus adapter, fixing the values of the host-side link speed
and topology settings as shown below is recommended.
2.3 Setting the Mailslot
The LT20 S2/LT40 S2/LT60 S2 has Mailslots that allow tape cartridges to be inserted into or ejected from the
library while the library is online.
For more details about how to enable the Mailslot, refer to "FUJITSU Storage ETERNUS LT20 S2 LTO Library
Installing, Starting Up and Maintaining" or "FUJITSU Storage ETERNUS LT40 S2/LT60 S2 LTO Library Installing,
Starting Up and Maintaining".
Topology
Point to Point
Link speed
Same as the LT20 S2/LT40 S2/LT60 S2
Topology
•
For connections via an FC switch
Fabric Point to Point
• For direct connections to the host bus adapter
FC-AL