Fujitsu fi-5900C Cleaning Instructions

Cleaning the Rollers - Recommended Cleaning Cycle Every 10,000 Sheets
6. Clean the Pinch Rollers (rubber rollers, each set
consists of 2 rollers, 9 locations) on the upper side
of the UPPER transport path, using cleaning paper
moistened with F1 cleaner
Brake
Roller
Feed
Rollers
Pinch
Rollers
Pad Cover
3. Open the Pad Cover - grab both sides of the cover,
press to the inside and pull down (towards you).
4. Remove the Brake Roller. Move the roller slightly to
the right, then pull it upwards to remove. Clean the
rubber surface using cleaning paper moistened with
F1 cleaner. Re-install and close the Pad Cover.
5. Clean the Feed Rollers (metal rollers, each set
consists of 2 rollers, 9 locations) on the upper side
of the LOWER transport path using cleaning paper
moistened with F2 cleaner.
For further cleaning instructions please
refer to the
fi-5900C Image Scanner Operators Guide
which can be found on our Website:
www.fel.fujitsu.com/scanner
Cleaning Instructions for fi-5900Fujitsu Europe LImited
January 2007

Fujitsu fi-5900C Specifications

General

Brand	Fujitsu
Model	fi-5900C
Category	Scanner
Language	English