What to do if scanning does not start on Fujitsu Scanner?
If scanning does not start on your Fujitsu Scanner, make sure the document is correctly loaded on the ADF paper chute and that the ADF is completely closed. Also, ensure the cable is correctly connected, paying attention to the hub's power supply if you're using a USB hub. Turn the power off and on again.
General| Film scanning | No |
|---|---|
| Color scanning | Yes |
| Input color depth | 24 bit |
| Maximum scan size | 210 x 297 mm |
| Scanner type | Sheet-fed scanner |
| Sensor type | CCD |
| Auto document feeder (ADF) input capacity | 50 sheets |
| Scan media weight | 210 g/m² |
| Weight (imperial) | 9.24 lbs |
| Dimensions (WxDxH) | 301 x 160 x 158 mm |
| Standard media sizes | -A4 -A8 |
| Compatible operating systems | -TWAIN -ISIS ScandAll PRO -Adobe Acrobat -QuickScan Pro -VRS |
| Sustainability certificates | ENERGY STAR |
| Power supply | 38 W |
| Operating temperature (T-T) | 5 - 35 °C |
| Operating relative humidity (H-H) | 20 - 80 % |
Weight and Dimensions| Weight | 4200 g |
|---|
To Next Page
