Fujitsu FUTRO S9010 - Connecting a Monitor; Connecting the Mouse; Connecting the Keyboard

Getting started
Connecting a monitor
Only attach the screen to y our device when it is switched off.
► Follow the instructions conta ined in the monitor manual to prepare the monitor
for operation (e.g. connecting cables).
Monitor,
► Connect the data cable to the required m o nitor port on your device.
► Plug the monitor power cable i nto the grounded mains outlet.
Connecting the mouse
You can connect a USB mouse or a PS/2 mouse to your device .
Mouse,Connecting,
Connecting a USB mouse
► Connect the U SB mouse to one of the USB ports on the device.
USBport,USBport
Connecting a PS/2 mouse
The PS/2 mouse is only detected by the device if you connect the mouse w h en
the device is s witched off and then switch the device o n again.
► Connect the PS/2 mouse to the PS/2 mouse port of the device.
PS/2mouse,C on necting,PS/2mouse,
► Switch your device on again.
Connecting t he keybo ard
You can connect a USB keyboa rd or a PS/2 keyboard to your device.
Keyboard,Connecting,
Connecting a USB keyboard
Use the supplied keyboard cable only.
USBport,Connecting,
► Plug the flat rectangular USB connector of the keyboard cable into a USB port of the device.
USBport
Connecting a PS/2 keyboard
Use the supplied keyboard cable only.
ConnectingaP S /2keyboardConnecting,
The P S/2 keyboard is only detected b y the d evice if you connect the keyboa rd
when the device is switched off and then switch the device on again.
► Switch your device off.
► Plug the round plug of the keyboard cable into a keyboard port of the device.
Key
board,
► Switch your device on again.
20 Fujitsu