Working with the notebook
Optical drive
Opticaldrive
This product contains a light emitting diode, classification according to IEC 60825
1:2007: LASER CLASS 1, and must therefore not be opened.
Handling optical disks
Handling
Observe the following g uidelines when handling optical disks:
• Avoid touching the surface of an optical disk. Only handle optical disks by their edges.
• Always store optical disks in their cases. This w ill protect the optical disk against
being covered in dust, scratch ed or damaged in any other way.
• Protect your optical disks against dust, mechanical vibrations and direct sunlight.
• Avoid storing an optical disk in areas subject to high temperatures or humidity.
You m ay use both 3.15 and 4.7-inch optical disks in the optical drive .
When using an o ptical disk of lesser quality, vibrations and reading erro rs may occur.
CD/DVD indicator
CD/DVDindicato
r
The CD/DVD indicator flashes when an optical disk is inserted. The indicator goes out when
the drive is ready for reading. The indicator lights up when the drive is being accessed.
You may only remove the optical disk when the indicator is unlit.
If the CD/DVD indicator does not go ou t after an optical disk has been inserted, but
instead continues to flash, this means that th e drive cannot access the optical disk.
Either the optical disk is damaged or dirty or you are using an optical
disk that the drive ca nnot read.
Fujitsu 33
To Next Page
Loading...
