Working with the notebook
Connecting the mains adapter to the Port Replicator
3
1
2
► Connect the power cable (1) to the po wer
adapter provided for the device, see
chapter "
Technical data", Page 75.
► Plug the power cable into the mains
socket (2).
► Connect the mains adapter cable to the DC
jack (DC IN) of the Port Replicator (3).
When the notebook is connected to a Port Replicato r, the operating system creates
a hardware profile for the "Docked" mode. In this profile, for example, the setting is
saved as to which monitor was last used for output. This profile will b e loaded, as
soon as th e notebook is connected to a Port Replicator of the same typ e.
Switching on the notebook via the port replicator
► Press the ON/O FF button on the p ort
replicator to switch the notebook on.
The power-on indicator of the Port
Replicator lights up.
48 Fujitsu
To Next Page
Loading...
