Removing and installing components
during servicing
Installing a hard disk
2
1
► Place the hard d isk
into the hard disk co m partme nt (1).
► Use the pulling aid to p ull the ha rd disk in the direction of the arrow (2) until the contacts engage.
Attaching the c over
1
2
2
► Place the cover in the correct mounting position (1).
If you remove more than one component at the same time, keep the screws for the
individual components separately from each other and make su re that you use the
correct screws. If you install the wrong screws, components may be damaged.
► Tighten the screws (2).
► Insert the battery (see Chapter "
Installing a battery " , Page 33).
Fujitsu Technology Solutions 73
Downloaded from LpManual.com Manuals
To Next Page
Loading...
