Fujitsu LifeBook P1620 - Checking the Memory Capacity; Installing a Memory Upgrade Module

81 - Memory Upgrade Module
Checking the Memory Capacity
Once you have changed the system memory capacity by replacing the installed module with a larger one,
be sure to check that your notebook has recognized the change.
Windows XP: Check the memory capacity by clicking [Start] > Control Panel, then double-clicking the
System icon. Select the General tab and check the amount of memory under “Computer:”
Installing a Memory Upgrade Module
1 Remove the new memory upgrade module from the
static guarded sleeve.
2 Align the memory upgrade module with the
component side up. Align the connector edge of the
memory upgrade module with the connector slot in
the compartment.
(Figure 27)
3 Insert the memory upgrade module at a 45° angle.
Press the connector edge of the module firmly down
and into the connector until it lodges under the
retaining clip. You will hear a click when it is properly
in place.
4 Replace the cover.
5 Replace the screws.
Figure 27. Installing a Memory Module
THE MEMORY UPGRADE MODULE IS NOT SOMETHING YOU ROUTINELY REMOVE FROM YOUR NOTEBOOK.
O
NCE IT IS INSTALLED, YOU SHOULD LEAVE IT IN PLACE UNLESS YOU WANT TO CHANGE SYSTEM
MEMORY CAPACITY.