Troubleshooting and tips
The cursor does not correctly follow the
stylus movements
Cause
Troubleshooting
Stylus incorrectly calibrated. ► Calibrate the stylus as shown under
Hardware and Sound / Tablet PC Settings
in the Control Panel, see "
Adjusting the
stylus", Page 37 and "Calibrating the stylus",
Page 37.
Stylus input not working
Cause
Troubleshooting
Incorrect driver installed.
► If your device is one which can only be
operated using the stylus, install the driver
for the standard model.
or
► If your device is one which can be
operated using the stylus and by finger,
install the driver for the "Dual Digitizer"
model.
The stylus is in power saving mode.
► Press gently on the tip of the stylus to
reactivate the stylus.
The stylus battery is completely discharged.
► Carefully insert the stylus in its slot on the
notebook to charge the stylus battery.
The notebook does not start after switching it on
Notebook
Cause Troubleshooting
The battery is not installed correctly.
► Check whet
her the battery is installed
correctly
in its compartment.
► Switch the notebook on.
The battery is dead.
► Charge the battery.
or
► Insert a charged battery.
or
► Connect the AC adapter to the notebook.
The AC adapter is not connected properly. ► Check whether the AC adapter is properly
connected to the notebook.
► Swit
ch the notebook on.
92 Fujitsu
To Next Page
Loading...
