Fujitsu LIFEBOOK P770 - Exiting from the Security Menu

22
LifeBook P Series BIOS
Exiting from the Security Menu
When you have finished setting the parameters on the Security Menu, you can either exit from setup utility or move to
another menu. If you wish to exit from setup utility, press the [Esc] key to go to the Exit Menu. If you wish to move to
another menu, use cursor keys.
Table 15: Fields, Options and Defaults for the Security Menu
Menu Field Options Default Description
Supervisor
Password is:
–— Clear A display-only field. Set is displayed when the system supervisor password is set
and Clear when it is not.
User Password is: –— Clear A display-only field. Set is displayed when the general user
password is set, and Clear when it is not.
Set Supervisor
Password
–— [Enter] Sets, changes or cancels the Supervisor Password. The Supervisor Password may
be up to 32 characters long and must include only letters or numbers (no sym-
bols). Passwords are NOT case-sensitive. To cancel a password press the Enter
key instead of entering characters in the Enter New Password field and in the
Confirm New Password field. When a Supervisor Password is set it must be used
to access the BIOS setup utility. Note that if the Supervisor Password is not set
up, the following six fields cannot be changed.
Set User Password –— [Enter] This field can only be accessed if the Supervisor Password is set. Sets, changes or
cancels the User Password. A User Password may be up to 32 characters long
and must include only letters or numbers (no symbols). Passwords are NOT
case-sensitive. To cancel a password press [Enter] key instead of entering char-
acters in the Enter New Password field and in the Confirm New Password field.
When a User Password is set it must be used to access the BIOS setup utility.
Minimum User
Password Length:
–— [0] Supervisor can set password length (0 to 32) for user password. User cannot set
a password shorter than the minimum length.
Password on Boot:
■
Disabled
■
First Boot
■
Every Boot
[Disabled] When set to First Boot, a password (User or Supervisor) is required just once
after the Power On Self Test (POST) before the operating system will be read
from a disk. When set to Every Boot, a password (User or Supervisor) is required
every time after the Power On Self Test (POST) before the operating system will
be read from a disk. When set to Disabled no password is required.
On Automatic
Wake up:
■
Disabled
■
Enabled
[Disabled] When disabled, password entry is not required when the system wakes up auto-
matically. When enabled, password entry is required upon wake up.
Boot from
Removable Media:
■
All
■
Supervisor only
[All] Supervisor only allows access to boot the computer to removable media after
the Supervisor Password is entered.
Flash Write:
■
Disabled
■
Enabled
[Enabled] When disabled, the BIOS Flash memory will be write protected.
Hard Disk Security: –— –— Submenu that configures hard disk security features
Owner
Information:
–— –— Submenu that sets Owner information.
TPM (Security
Chip) Setting
___ ___ Submenu that sets security chip features.