23
Hard Disk Security Submenu of the Security Menu
The Hard Disk Security submenu is for configuring hard disk security features.
Figure 16. Hard Disk Security Submenu
Table 16: Fields, Options and Defaults for the Hard Disk Security Submenu of the Security Menu
Menu Field Options Default Description
Drive0:
___
Clear Display-only. Default is Clear. When the Drive0 Password has been set, the field
changes to Set. When this password is set, the primary hard disk drive cannot be
used in another system unless the password is entered.
Set Master
Password
___
Enter Sets, changes or cancels the Drive0 Master Password. The Drive0 Master Password
may be up to 32 characters long and must include only letters or numbers (no sym-
bols). Passwords are NOT case-sensitive. Note that once the Supervisor password is
set, the Hard Disk Security features can be set up or modified via cold boot.
Set User Pass-
word
___
Enter Sets, changes or cancels the Drive0 User Password. The Drive0 User Password may
be up to 32 characters long and must include only letters or numbers (no symbols).
Passwords are NOT case-sensitive.
Drive5:
___
Not Available Display-only. Default is Clear, when available, otherwise it is Not Available. When
the Drive5 Password has been set, the field changes to Set. When this password is
set, the primary hard disk drive cannot be used in another system unless the pass-
word is entered.
Set Master
Password
___
Enter Sets, changes or cancels the Drive5 Master Password. The Drive5 Master Password
may be up to 32 characters long and must include only letters or numbers (no sym-
bols). Passwords are NOT case-sensitive.
Set User Pass-
word
___
Enter Sets, changes or cancels the Drive4 User Password. The Drive4 User Password may
be up to 32 characters long and must include only letters or numbers (no symbols).
Passwords are NOT case-sensitive.
Password Entry
on Boot:
■
Disabled
■
Enabled
[Enabled] When set to disabled, entry of a Hard Disk Password is not required before OS boot.
(The hard disk is still password-protected without password entry.)
F1 Help
ESC Exit
Select Item
Select Menu
-/Space
Enter
F9 Setup Defaults
F10 Save and Exit
Change Values
Select Sub-Menu
▲
Item Specific HelpHard Disk Security
Drive0: Clear
Set Master Password [Enter]
Set User Password [Enter]
Drive5: Not Available
Set Master Password [Enter]
Set User Password [Enter]]
Password Entry on Boot: [Enabled]
Phoenix SecureCore(tm) Setup Utility
Info System Advanced Security Boot Exit
Security Menu
To Next Page
Loading...
