35
User-Installable Features
Figure 4-4. Inserting/Removing PC Cards
PC Cards
Your LifeBook notebook supports Type I and Type II
PC Cards. With these cards you can perform a variety of
functions depending on which type of card you insert.
Some available PC Cards:
■
Wireless LAN PC Cards (Type II)
■
Local area network (LAN) cards (Type II)
■
IDE solid-state disk cards (Type II)
■
SCSI cards (Type II)
■
PC Cards that conform to PCMCIA 2.1 or CardBus
For further information, refer to the instructions
supplied with your card(s).
INSERTING PC CARDS
PC Cards are inserted in the PC Card slot (Figure 4-4).
To insert a PC Card, follow these steps:
1. See your PC Card manual for instructions on the
insertion of your card. Some cards may require that
your notebook is off while inserting them.
2. Make sure there is no PC Card currently in the slot.
If there is, see Removing PC Cards.
3. If the eject button is extended, press it until it clicks.
4. Insert the card into the slot with the label facing up.
5. Push the card firmly into the slot until it is seated in
the connector.
REMOVING PC CARDS
See your PC Card manual for specific instructions on
removing your card. Some cards may require your note-
book to be in Standby Mode or Off during removal.
2. Unlock the card from the slot by pressing the eject
button. When pressed, the button will pop out.
3. Firmly press the button again until it is flush with
the notebook. This will eject the card slightly out of
the slot allowing you to remove the card.
1
1 PC Card Slot
2
3
2 PC Card
3 PC Card Eject Button
You may be required to log on as an
Administrator or member of the
Administrator’s Group to complete this
procedure. If the computer is connected to
a network, network policy settings may
also prevent you from completing this
procedure.
■
Inserting or removing a PC Card during
your LifeBook notebook’s shutdown or
bootup process may damage the card
and/or your LifeBook notebook.
■
Do not insert a PC Card into a slot if
there is water or any other substance on
the card as you may permanently
damage the card, the notebook, or both.
■
Windows has a shutdown procedure for
PC Cards that must be followed before
removing a card. It is good practice to
remove devices using the Unplug or
Eject Hardware icon in the notification
area.
■
If the dialog box states that the device
cannot be removed, you must save all of
your open files, close any open applica-
tions and shut down your notebook.
If the PC Card has an external connector
and cable, do not pull the cable when
removing the card.
Q2010.book Page 35 Wednesday, May 24, 2006 1:36 PM
To Next Page
Loading...
