Removing and installing components
during servicing
Removing and installing compo
nents
during servicing
The illustrations shown below may differ from your actual device. They are
merely intended to clarify the principles involved.
Only qualified technicians should repair your notebook. Unauthorised
opening or incorrect repair may greatly endanger the user (electric shock,
fire risk) and will invalidate your warranty.
Components
Serv icing
After consulting the Hotline/Service Desk, you may remove and install the
components described in this chapter yourself.
If you remove and install components without consulting the Hotline/Service
Desk, then the warranty of your notebook will be voided.
Notes on installing and removing boards
and components
• Switch the notebook off and pull the power plug out of the mains socket.
• Always remove the battery.
• Take care when you use the locking mechanisms on the battery and any other component.
• Never use sharp objects such as screwdrivers, scissors or knives as leverage to remove covers.
NotesBoardESD
Boards with el
ectrostatic sensitive devices (ESD) are marked with the label
shown.
When handli
ng boards fitted with ESDs, you must always observe the following
points:
• You must alw
ays discharge static build up (e.g. by touching a grounded
object) be
fore working.
• The equipment and tools you use must be free of static charges.
•Removeth
e power plug from the mains supply before inserting or removing
boards co
ntaining ESDs.
• Always hold boards with ESDs by their edges.
• Never to
uch pins or conductors on boards fitted with ESDs.
68 Fujitsu
To Next Page
Loading...
