Fujitsu LIFEBOOK U748 - Removing and Installing Components - M.2 Module Installation Details; Installing an M.2 Module; Removing an M.2 Module

Removing and installing components
during servicing
Installing an M.2 module
► LIFEBOOK U758: If applicable, insert the M.2 adapter into the service compartment.
1
2
► Insert the M.2 module at a slight angle in the direction of the arrow (1)
into the slot on the mainboard.
► Fasten the M.2 module in place in the slot with the screw (2).
Removing an M.2
module
2
1
► Undo the screw (1).

The M.2 module snaps slightly upwards.
► Pull the M.2 module in the direction of the arrow (2) and out of the slot on
the mainboard and remove it from the casing.
► LIFEBOOK U758: If you wish to install an HDD hard disk instead of another M.2 module,
remove the M.2 adaptor (under the M.2 module) from the service compartment and install the
HDD; see
"Removing and installing hard disks (HDD, LIFEBOOK U758 only)", Page 75.
Fujitsu 73