© 2011 Fujitsu Technology Solutions
13
2.3 Configuring default gateway setting
This section will describe how to configure the default gateway for the system.
Beginning in privileged EXEC mode, follow these steps to configure default gateway from
out-of-band management interface:
Command Purpose
Step 1 configure Enter global configuration mode.
Step 2 oob protocol
<bootp|dhcp|dhcp6|none>
To set IP management interface to use
bootp, dhcp, dhcpv6 or none.
Step 3 oob ip <ipaddr> <netmask> To set a fixed IP address and net mask for
management interface.
Step 4 oob gateway <gateway> To set the default gateway address.
Step 5 exit Return to privileged EXEC mode.
Step 6 show oob Verify the configuration.
To configure the default gateway for the out-of-band management interface, use oob
gateway global configuration command. To display IP setting of out-of-band management
interface, use show oob privileged EXEC command.
In this example, out-of-band management interface is configured with a fixed IP address
10.1.20.1 and default gateway 10.1.20.254.
(BX900-CB1)#configure
(BX900-CB1)(Config)#oob protocol none
Changing protocol mode will reset ip configuration.
Are you sure you want to continue? (y/n)y
(BX900-CB1)(Config)#oob ip 10.1.20.1 255.255.255.0
(BX900-CB1)(Config)#oob gateway 10.1.20.254
(BX900-CB1)(Config)#exit
(BX900-CB1)#show oob
IP Address..................................... 10.1.20.1
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 10.1.20.254
IPv6 Address................................... FE80::21E:68FF:FE85:F760/64
OOB interface Configured Protocol.............. None
Burned In MAC Address.......................... 00:1E:68:85:F7:60
(BX900-CB1)#
To Next Page
Loading...
