© 2011 Fujitsu Technology Solutions
6
1 Configuration Guide Overview
This guide describes the PRIMERGY BX400/BX900 Ethernet Connection Blade specific
functions that you might encounter. Basically, the guide describes how to configure your switch
or how to configure software features on your switch. It also provides detailed information
about commands that have been created or changed for use by the Ethernet Connection
Blade.
Where “BX900” is shown in the examples below, it is synonymous to “BX400” when working
on a Primergy BX400 Blade Server System.
This document provides the following guidelines:
− Configuring Management
− Configuring Uplink Sets
− Configuring Port groups
− Configuring VLAN groups
− Configuring service LAN
− Configuring service VLAN
− Combining Port groups and service (V)LAN
− Configuring Downlink LAG
− Configuring Private Network
− Configuring QoS
− Configuring IGMP/MLD snooping
− Configuring IEEE 802.1X Authentication
− Configuring Port Mirroring
− Configuring SNMP Agent
− Configuring System Log
Mode Prompt
privileged EXEC mode (BX900-CB1)#
Configuration mode (BX900-CB1)(Config)#
Interface mode (BX900-CB1)(Interface BX900-CB1/0/1)#
Interface range mode (BX900-CB1)(if-range)#
To Next Page
Loading...
