Fujitsu PRIMERGY BX900 - Configuring SNMP Traps

© 2011 Fujitsu Technology Solutions
62
17.4 Configuring SNMP Traps
Beginning in privileged EXEC mode, follow these steps to configure SNMP trap receiver:
Command Purpose
Step 1 configure Enter global configuration mode
Step 2 snmptrap trap-name ipaddress
snmpversion
<snmpv1|snmpv2|snmpv3>
Create a SNMP trap and specify the client
IP address to receive SNMP traps.
trap-name should be SNMPv2 community
string or SNMPv3 user name.
Step 3 exit Return to global configuration mode.
Step 4 show snmptrap Verify the configuration.
To configure SNMP trap, use the snmptrap global configuration command. To display the
SNMP trap configuration, use show snmptrap privileged EXEC command.
As configuring the SNMPv3 trap, the security level of the trap has to be the same or lower
than the one of the SNMP user. (Refer to section 17.2 Configuring SNMP User)
In this example, create and activate the SNMPv2 and v3 trap for SNMP trap receiver:
(BX900-CB1)(Config)#snmptrap public 192.168.2.2 snmpversion snmpv2
(BX900-CB1)(Config)#snmptrap v3_user 192.168.2.2 snmpversion snmpv3 auth
(BX900-CB1)(Config)#exit
(BX900-CB)#show snmptrap
SNMP Trap Name IP Address SNMP Version Status
------------------- ----------------- -------------- --------
public 192.168.2.2 snmpv2 Enable
v3_user 192.168.2.2 snmpv3 Enable
(BX900-CB)#