© 2011 Fujitsu Technology Solutions
16
Beginning in privileged EXEC mode, follow these steps to upload configuration from Ethernet
Connection Blade:
Command Purpose
Step 1 copy startup-config <filename>
<url>
To upload configuration file specified in
<filename> to the <url> address where
<url>={xmodem | tftp://ipaddr/path/file |
ftp://user:pass@ipaddr/path/file}.
To upload a firmware, use copy startup-config privileged EXEC command.
In this example, a configuration file will be uploaded via TFTP protocol to a TFTP server
with IP address 192.168.2.100.
!
Before performing the upload operation, you have to configure an IP address for
your Ethernet Connection Blade via DHCP protocol or manually.
(BX900-CB1)#copy startup-config default.cfg tftp://192.168.2.100/backup_config.cfg
Mode........................................... TFTP
Set TFTP Server IP............................. 192.168.2.100
TFTP Path...................................... ./
TFTP Filename.................................. backup_config.cfg
Data Type...................................... Config File
Management access will be blocked for the duration of the transfer
Are you sure you want to start? (y/n)y
File transfer operation completed successfully.
(BX900-CB1)#
To Next Page
Loading...
